Description
It is a water based preparation based on silicone wax
plus polymers. It is easily applied and exhibits excellent
coverage.
It is non-toxic, non-flammable and has no physical or
chemical effects on cable sheath or sub-duct. It can be
used on cable blowing or pushing.

Friction Reduction
The maximum length that can be blown in any situation
is proportional to the coefficient of friction. If the
coefficient of friction can be reduced by a factor of three
the length of installation will go up by three.
Lubricant is critical in optimized air blowing. Good
factory lubrication on the duct interior is helpful; but the
most consistent results come from the field addition of
lubricants. Generally speaking blowing lubricants are
used in relatively small quantities (0.1/0.5 litres per
Km).

Typical Usage and Applications
The duct must be clean and dry without air leaks at duct
splices. Lubricant is continuously injected in front of the
missile for piston-type blowing machines. For high
speed air (no missile), the correct amount of lubricant is
blown in first.
The amount of lubricant used will vary depending on the
type of duct (pre-lubricated or not), diameter and
geometry of the network i.e. more bends = more
lubricant.

Package
200L and 4L

Spillage
Can be cleaned up with lubaklenz and large amounts of
water.

Health and Safety Properties
Lubricants are non-toxic and non-hazardous to the
environment. These products are very slippery.
Avoid walking on spills. Cover spills with absorbent
material and clean up with water.